Adaptec ACS-100 Manual do Utilizador

RUSB EnclosureACS-100User’s Guide

9Connecting and Powering OnNote: Windows 98SE users only—You must install the device drivers before connecting and powering on the USB Enclosure.To co

10Disconnecting Your USB EnclosureTo disconnect your USB Enclosure from your computer, follow the instructions for your operating system.WindowsYou mu

11TroubleshootingIf you have problems installing or using your Adaptec ACS-100 USB Enclosure, work through this list of suggestions: Ensure that the

RAdaptec, Inc.691 South Milpitas BoulevardMilpitas, CA 95035 USA©2004 Adaptec, Inc.All rights reserved. Adaptec and the Adaptec logo are trademarks of

1Copyright©2004 Adaptec, Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any

2Limited 1-Year Hardware Warranty1. Adaptec, Inc. (“Adaptec”) warrants to the purchaser of this product that it will be free from defects in material

3Regulatory Compliance StatementsFederal Communications Commission Radio Frequency Interference StatementWARNING: Changes or modifications to this uni

4In this Guide...This User’s Guide explains how to install and connect your Adaptec® ACS-100 USB Enclosure.Kit Contents 5System Requirements 5Getting

5Kit Contents Adaptec ACS-100 USB Enclosure One enclosure stand One power adapter One high-quality USB cable One bag of screws CD, including dev

6Getting Started ChecklistComplete these steps to install and begin using your Adaptec ACS-100 USB Enclosure:❏ Install the device driver—Windows 98SE

7Installing a Disk DriveBefore you begin, ensure that you are installing the proper disk drive. The Adaptec ACS-100 USB Enclosure supports 3.5-inch ID

84 Place the disk drive into the disk drive tray and secure it, using the four screws included in the kit.5 Slide the disk drive tray into the enclosu