Adaptec 29320LP SCSI Card Guia de Instalação

ADAPTEC SCSI CARD 29320ALPINSTALLATION GUIDEASC-29320ALP IG.fm Page 0 Tuesday, July 29, 2003 4:40 PM

93 Connect the other external SCSI devices by linking each device to the previous one, as shown below. Terminate only the device at the end of the cha

10TroubleshootingIf you have any problems while installing the Adaptec SCSI Card 29320ALP, check the following items first: Are all SCSI devices powe

11Copyright© 2003 Adaptec, Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in an

12This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful inte

Adaptec, Inc.691 South Milpitas BoulevardMilpitas, CA 95035 USARPart Number: 513659-06, Ver. AA JG 08/03© 2003 Adaptec, Inc.All rights reserved. Adapt

1IntroductionThe Adaptec SCSI Card 29320ALP enables you to connect up to 15 SCSI devices—such as very large arrays of high-performance hard disk drive

2Note: If you connect Wide Ultra/Ultra SCSI devices to the same SCSI channel as Ultra320/160 and Ultra2 SCSI devices, the data transfer rate for the U

33 Locate an unused 64-bit PCI/PCI-X expansion slot and remove the expansion slot cover. If the computer does not have a 64-bit slot, you can install

44 Insert the Adaptec SCSI Card 29320ALP in the 64-bit (or 32-bit) PCI or PCI-X expansion slot; press down firmly until the card clicks into place, th

5The Adaptec SCSI Card 29320ALP is preset to ID 7 for each channel and should not be changed. If you boot from a SCSI hard disk, make sure the hard di

6The Adaptec SCSI Card 29320ALP has one internal LVD/SE connector to which you can connect internal SCSI devices. Note: Adaptec recommends that you ke

72 Plug the nonterminated end of the cable to the internal LVD/SE connector.3 Plug the internal Ultra320/160 and Ultra2 SCSI devices to the other cabl

8Connecting External SCSI DevicesYou can connect external Ultra320/160 and Ultra2 SCSI devices to the 68-pin external LVD/SE VHDCI SCSI connectors. Ea