Adaptec AHA-2930 Guia de Instalação

RSCSI Card 2930CUInstallation Guide

102Connect one end of an external SCSI cable to the SCSI Card 2930CU external SCSI connector. Secure the cable by tightening the thumb screws on the c

116 Reconnect the power cord to the computer and connect power cables to the external SCSI devices. Turn on the SCSI devices and allow them to power u

12Windows MeWindows Me has embedded driver support for a SCSI card as part of the installation software. When the SCSI Card 2930CU is installed and yo

13If Windows 95/98 is already installed on your system, see Installing the Driver When Windows 95 is Already Installed on page 14 or Installing the Dr

14Installing the Driver When Windows 95 is Already Installed1 Start Windows 95.2 Click Start, point to Settings, then click Control Panel. Double-clic

15Installing the Driver When Windows 98 is Already InstalledTo update or install the driver if Windows 98 is already installed1 Start Windows 98.2 Cli

RAdaptec, Inc.691 South Milpitas BoulevardMilpitas, CA 95035 USA© 2002 Adaptec, Inc.All rights reserved. Adaptec and the Adaptec logo are trademarks o

2This Installation Guide describes how to install the Adaptec SCSI Card 2930CU. It also describes how to install and connect your internal and externa

3Installing the SCSI Card 2930CUTo install the SCSI Card 2930CU1 Ground yourself by touching the chassis.2 Turn off the computer and disconnect the po

45 Remove the SCSI Card 2930CU from its antistatic packaging.Note: Always handle the SCSI card by its edges or metal bracket. Do not touch the gold co

5Installing Internal SCSI DevicesIf you are connecting only external devices, skip to Connecting External SCSI Devices on page 8.To install internal S

64 Connect the other end of the cable to the internal SCSI device.5 If you are installing one internal SCSI device only, you must terminate this devic

76 Connect any other internal SCSI devices, as shown.7 Terminate the device that is connected to the end of the cable. Refer to the SCSI device’s docu

89 Close the computer cabinet. Do not reconnect the power cord yet.If you are also connecting external SCSI devices, skip to the next section, Connect

9To connect external SCSI devices1Ensure that each external SCSI device has a unique SCSI ID from 0 to 6. For most external SCSI devices, the SCSI ID