Adaptec AVA-2906 Guia de Instalação

RINSTALLATIONGUIDESCSI CARD 2906

6SCSI Card 2906Preparing the SCSI DevicesSetting up SCSI devices before attaching them to the SCSI card typi-cally involves setting SCSI IDs and termi

7SCSI Card 2906Connecting Internal SCSI Devices1Be sure that each internal SCSI device you are installing has a unique SCSI ID from 0 to 6. Refer to t

8SCSI Card 2906Note: If it is difficult to reach behind your internal SCSI devices mounted in the drive bay, try connecting the inter-nal SCSI devices

9SCSI Card 29065Connect the other end of the cable to the last internal SCSI device as shown below (this SCSI device must be terminated; see Step 2 ab

10SCSI Card 29067Connect a power cable from your computer’s power supply to the power input connector on the sCSI device as shown below. Repeat this s

11SCSI Card 2906Connecting External SCSI Devices1Be sure that each external SCSI device you are installing has a unique SCSI ID from 0 to 6. Refer to

12SCSI Card 2906For each external SCSI device you install, you need a high-quality external SCSI cable. See the SCSI Card 2906 User’s Refer-ence for a

13SCSI Card 2906Note: If you are connecting external SCSI devices, use SCSISelect to set the Maximum Synchronous transfer rate to 5 MBytes/sec. The D

14SCSI Card 29067Turn ON the computer to boot it. 8Install any software included with your SCSI device.9Continue with Installing the SCSI Card 2906 So

15SCSI Card 2906Note: If the driver is not listed or is not loading properly, see the Troubleshooting section of the SCSI Card 2906 User’s Refer-ence.

16SCSI Card 29064Select File/Run from the Program Manager menu.5When the Run dialog box appears, type a:\setup if you are using the A drive, or b:\set

17SCSI Card 2906Federal Communications Commission Radio Frequency Interference StatementWARNING: Changes or modifications to this unit not expressly a

18SCSI Card 2906Adaptec, Inc.691 South Milpitas BoulevardMilpitas, CA 95035© 1998 Adaptec, Inc. All rights reserved. No part of this publication may b

R© 1998 Adaptec, Inc.All rights reserved. Adaptec, and the Adaptec logo are trademarks of Adaptec, Inc. which may be regis-tered in some jurisdictions

R▼ ▼ ▼ ▼ AVA-2906SCSI Card 2906Installation Guide

1Contents➤ Introduction2➤ Before You Begin2➤Installing the SCSI Card 29064➤Preparing the SCSI Devices6Check the SCSI IDs6Terminate the Ends of the SCS

2SCSI Card 2906IntroductionWith SCSI Card 2906, you can connect up to seven SCSI devices to any IBM-compatible computer with Bus Mastering PCI expansi

3SCSI Card 29064In Device Manager, double-click Computer at the top of the list.5In the Computer Properties window, click Interrupt request (IRQ) (if

4SCSI Card 2906Determine which SCSI devices will be connected to the computer. If you want to connect more than two internal SCSI devices or one or mo

5SCSI Card 29063Remove the SCSI Card 2906 from its antistatic packaging. Always handle the card by its edges. 4Insert the SCSI Card 2906 in the slot,