Adaptec AHA-2940UKIT Guia do Utilizador

1IntroductionThe Adaptec AHA®-2940Ultra and AHA-2940Ultra Wide PCI-to-Fast SCSI host adapters provide a pow-erful multitasking interface between your

10immediately scans the SCSI bus and displays a list of all SCSI IDs and the devices assigned to each ID.When you select a specific ID and device, a s

11 Adaptec 7800 Family Manager Set—allows you to install software drivers for NetWare, OS/2, Windows 95/98, Windows NT, and UNIX. Refer to the 7800

122Make sure the boot hard disk SCSI ID corre-sponds to the Boot Target ID setting in SCSISelect (see page 8). The SCSI ID is normally set with jumper

FCC Compliance StatementThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FC

RAHA-2940Ultra/2940Ultra WidePCI-to-UltraSCSI Host Adapterwith SCSISelectInstallation GuideAHA-2940Ultra/2940Ultra WidePCI-to-UltraSCSI Host Adapterwi

2Installing the Host AdapterFollow these instructions to install the host adapter:1Turn OFF power to the computer and peripheral devices and disconnec

3your hard disk and other SCSI devices, refer to the device’s documentation.The host adapter supports the SCSI Configured AutoMatically (SCAM) protoco

4 If the AHA-2940Ultra detects that a cable is con-nected to both its internal and external SCSI con-nector, then it disables its terminators (the AH

5Installing SCSI DevicesYou can connect up to a total of seven internal and external 8-bit SCSI devices to the AHA-2940Ultra, and up to 15 devices (se

6external) must not exceed 3 meters (9.8 ft.) to ensure reliable operation. If no Fast SCSI devices are con-nected, the total length of all cables mus

7Connecting External SCSI DevicesIf you are connecting external SCSI devices to your host adapter, you must obtain an external SCSI cable for each ext

8board. SCSISelect also contains SCSI disk utilities that let you low-level format or verify the disk media of your SCSI hard disk drives.SCSISelect D

9Starting the SCSISelect UtilityYou can start the SCSISelect utility by pressing Ctrl-A when the following prompt appears at boot time:Press <Ctrl&