Adaptec GDT8546RZ Guia do Utilizador descarregar pdf (Página 25)

Hardware Installation and User’s Guide 25

Flash Memory Programming

Refer to Section A.2 for help in deciding whether the firmware needs a recovery or

update.

Figure A-1. Jumper Positions for Flash Update and Recovery

Warning:

Shock hazards may be present inside the unit in which this controller is being

installed. Disconnect all power cords to the unit before removal of any covers.

Follow the warnings noted in your computer’s user or service manual before

installing this board. ONLY after all the covers are reinstalled should you reconnect

the power cords and power up the unit.

1. Take all precautions to prevent ESD damage before handling the ICP RAID

Controller.

2. Power off all system components and disconnect their power cords.

3. Remove the cover from the system to gain access to the PCI slots.

4. Remove the ICP RAID Controller from your system.

5. On jumper block J1 / FRU jumper, move the jumper to position 1-2 for firmware

recovery or to position 2-3 for firmware updates. See Figure A-1 and Figure 2-1 for

details.

6. Re-install the adapter in the PCI slot in which it was previously installed.

7. Replace the cover, reconnect all power cords and power up the system.

A.4 Updating or Recovering Firmware Using the FRUU

This section explains how to use the Firmware Recovery and Update Utility (FRUU) to

update or recover the firmware on the RAID controller. For help in choosing between

update and recover, see Section A.2.

Normal-Run

(Update)

Flash Recovery

(Recover)

123 123

1 2 ... 20 21 22 23 24 25 26 27 28 29 30

Sem comentários

Adaptec GDT8546RZ Guia do Utilizador Página 25