Adaptec 2100S - SCSI RAID Controller Guia de Instalação descarregar pdf (Página 44)

3-9

Installing the Driver

c Follow instructions and respond to prompts as necessary to

get to the Adaptec splash screen.

d When you see the Adaptec splash screen, click Create

Driver Disk. Then, click the appropriate operating system.

e Insert a floppy disk and click OK. The system creates the

driver disk.

2 Shut down the system and remove the Adaptec RAID

Installation CD and the driver floppy disk.

3 Restart the system and open the Control Panel. Click the SCSI

Adapters icon. Then select the Drivers tab and click Add.

4 Insert the driver disk you created in Step 1 and then click Have

Disk.

5 Select Adaptec I

O RAID Host Adapter Driver for NT 4.0.

6 After the driver is loaded, shut down the system.

7 Replace the existing controller with the Adaptec RAID

controller. For installation details, refer to Chapter 2.

8 Start up the system.

9 If you are removing the old controller, you should also remove

the old driver. To do so, open the Control Panel, click the SCSI

Adapters icon, and then select the old driver and click

Remove.

Changing the Driver in an Existing System

In this scenario, you are changing the driver in an existing

Windows NT 4.0 system that already has an Adaptec RAID

controller installed. To change the driver

Create a driver floppy disk using the

Adaptec RAID Installation CD

To create the disk

a Insert the Adaptec RAID Installation CD in your drive.

b Boot from the CD. The CD loads a Linux kernel that is used

to manage all of its functions.

c Follow instructions and respond to prompts as necessary to

get to the Adaptec splash screen.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 99 100

Sem comentários

Adaptec 2100S - SCSI RAID Controller Guia de Instalação Página 44