Adaptec 2940U2W Guia de Instalação descarregar pdf (Página 12)

To install the SCSI Card 2940U2W software (software driver), go to

the section below for the operating system (for example, Windows®

95) installed on your computer. If the operating system is not yet

installed, install it now. Refer to your operating system documentation

for instructions.

If you have installed a new SCSI hard drive in a computer

running Windows or DOS, you must partition and format the drive

with the DOS Fdisk and Format commands before it can be used.

Refer to your Windows and DOS documentation for instructions.

NOTE

INSTALLING SCSI CARD 2940U2W SOFTWARE

STEP 2

STEP 3

STEP 4

Connect the other end of the cable

to a SCSI connector on the back

of an external peripheral. If you

are installing only one external

peripheral, terminate the

peripheral and skip to

Step 4.

Connect other external peripherals by connecting each peripheral to

the previous one until all peripherals are connected.

The peripheral at the end of the chain must

be the only external periph-

eral terminated.

Connect all power cables to

the external peripherals.

SCSI Terminator

(Not Included in Kit)

Terminated SCSI

Peripheral

1 2 ... 7 8 9 10 11 12 13 14

Sem comentários

Adaptec 2940U2W Guia de Instalação Página 12