Adaptec AAA-UDMA Guia de Instalação descarregar pdf (Página 52)

6-4

AAA-UDMA Installation and Hardware Guide

Note:

To load the driver automatically at server bootup,

make sure the

startup.ncf

file includes the

load

command

line for the

cdaudmah.ham

driver. (If you also have an

Adaptec host adapter that uses the Adaptec

aic78xx.dsk

driver, make sure the driver loads after the

cdaudmah.ham

driver.)

Note:

Older versions of the

aic78xx.dsk

driver (before v1.30)

are compatible with

cdaudmah.ham

as long as the

AAA-UDMA PCI slot is not specified on the command line

(e.g.,

load aic7870.dsk slot=z

). If there is an AIC-78xx based

card (e.g., AHA

™

-2940) in the system,

must point to that

card’s slot number and not to the AAA-UDMA slot number.

If loaded without command line parameters, NetWare lists

valid slot numbers. The AAA-UDMA will be listed in the

parameter list; however,

do not

select it.

NetWare 4.2 and 5.0

Follow these instructions only if you are installing NetWare 4.2 and

5.0 for the first time:

Create a DOS partition and install DOS on your hard disk

drive.

Edit the

autoexec.bat

file to include a command line for

mscdex.exe

(the

mscdex

exe

file is included with MS-DOS 6.x

and above)

The following sample command lines for the

autoexec.bat

file are appropriate for most systems:

c:\dos\mscdex.exe /M:12

(This assigns the CD-ROM the next available drive letter, typi-

cally

if there is only one DOS drive.)

Reboot the system to the DOS partition.

Insert the NetWare 5.0 CD in your CD-ROM drive.

Go to the CD-ROM drive.

Typ e

Install

and press

Enter

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 65 66

Comentários a estes Manuais

Sem comentários

Adaptec AAA-UDMA Guia de Instalação Página 52

Comentários a estes Manuais

Manuais e produtos relacionados com Servidores Adaptec AAA-UDMA