Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Manual do Utilizador descarregar pdf (Página 83)

Data Recovery Using R-Studio

To create a Stripe set object (RAID 0)

1 Click the Create Virtual RAID button and select Create Virtual Block RAID & Autodetect

or select the Create Virtual Block RAID & Autodetect on the Create menu

> A Virtual Block RAID object will appear on the Drives panel

2 Select RAID 0 (Stripe set) on the RAID type

3 Drag the required partitions from the Drives panel to the Parents tab

Other ways to add objects

Right-click the Parents tab and select the required partition from the shortcut menu,

Right-click the partition on the Drives panel, select Add to RAID on the shortcut menu, and select the

RAID object you want to add the partition to.

You may either make R-Studio to process your changes immediately or wait until you finish editing the

RAID layout. Select or clear the Apply changes immediately checkbox on the Parents tab. Click the Apply

button to apply the changes when are you through.

Note: Objects should be placed in the same order as they were in the original volume set. If this order is

incorrect, you must change it by dragging the parents to place them in the correct order.

Object control buttons

Locate

Click this button to locate the selected object in the Drives

panel.

Add Empty Space/Add Missing Disk

Click this button to add an empty space or missing disk object

to the RAID

Remove

Click this button to remove the selected object from the RAID

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 264 265

Sem comentários

Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Manual do Utilizador Página 83