Adaptec GDT651y Manual do Utilizador descarregar pdf (Página 286)

286

Chapter M - GDT User's Manual

M.9.1

Last Status

Messages of the SCSI Devices

(1) Messages of the GDT Firmware:

0x00000002 Check Condition - problem

0x00000107 Selection Timeout (reset 250 msec, power on 10 sec)

0x00000109 SCSI Bus Reset

0x00000110 Connection Timeout

0x0000010F Disconnect Timeout

(2) Messages of the SCSI Devices

The following listed messages are part of the SCSI-II documentation.

Format:

0x????70yz

(???? = additional device specific messages)

0x????7000h

NO SENSE. Indicates that there is no specific sense key information to

be reported for the designated logical unit. This would be the case for

a successful command or a command that received CHECK

CONDITION or COMMAND TERMINATED status because one of the

filemark, EOM, or ILI bits is set to one.

0x????7001h

RECOVERED ERROR. Indicates that the last command completed

successfully with some recovery action performed by the target. De-

tails may be determinable by examining the additional sense bytes

and the information field. When multiple recovered errors occur dur-

ing one command, the choice of which error to report (first, last, most

severe, etc.) is device specific.

0x????7002h

NOT READY. Indicates that the logical unit addressed cannot be ac-

cessed. Operator intervention may be required to correct this condi-

tion.

1 2 ... 281 282 283 284 285 286 287 288 289 290 291 ... 296 297

Sem comentários

Adaptec GDT651y Manual do Utilizador Página 286