Adaptec 29320-R SCSI Card Guia de Instalação Página 1

INSTALLATION GUIDEADAPTEC SCSI CARD 29320ASC-29320 IG.fm Page 14 Wednesday, August 14, 2002 2:00 PM

9Connect the other end of the cable to a SCSI connector on the back of an external device. If you are installing only one external device, terminate t

10The last SCSI device on the end of each SCSI bus cable must be terminated, and termination must be disabled for all other devices in the middle of t

11Preloaded Adaptec DriversIf the Adaptec SCSI Card 29320 was included as part of a computer system you purchased, the system already has the appropri

12Copyright© 2002 Adaptec, Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in an

This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interf

1The Adaptec SCSI Card 29320 enables you to connect up to 15 Low Voltage Differential (LVD) and/or 15 Single-Ended (SE) SCSI devices—such as very larg

2Discharge any static electricity build-up before handling your SCSI card by touching a grounded metal object (like the exposed metal parts on the bac

3Computers may have vertical or horizontal expansion slots. Refer to your computer manual to locate the PCI/PCI-X slots. If your computer is a tower m

4Check the SCSI IDsThe Adaptec SCSI Card 29320 and each device you connect to it must have a unique SCSI ID number ranging from 0 to 15 on each channe

5cables are laminated so that they lay flat. Internal LVD cables usually have a terminator built into the end of the cable.The Adaptec SCSI Card 29320

6Plug the internal Ultra320/160 and Ultra2 SCSI devices to the other cable connectors, starting with the connector at the terminated end of the cable.

7Plug one end of the cable to the Wide SCSI connector on the Adaptec SCSI Card 29320. Plug the other end of the cable to a terminated Ultra/Fast Wide

8Plug the other end of the cable to a terminated Ultra/Fast Narrow SCSI device.If you have other Ultra/Fast Narrow SCSI devices, attach them to the co