Adaptec 39320-R Guia de Instalação Página 1

INSTALLATION GUIDEADAPTEC SCSI CARD 39320ASC-39320 IG.fm Page 14 Monday, August 12, 2002 9:36 AM

9Connect the other external SCSI devices by linking each device to the previous one, as shown below. Terminate only the device at the end of the chain

10If you have any problems while installing the Adaptec SCSI Card 39320, check the following items first:•Are all SCSI devices powered on?•Are all SCS

11Copyright© 2002 Adaptec, Inc. All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in an

12This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful inte

© 2002 Adaptec, Inc. All rights reservedPart Number: 513280-06, Ver. AA JG 08/02RASC-39320 IG.fm Page 13 Monday, August 12, 2002 9:36 AM

1The Adaptec SCSI Card 39320 enables you to connect up to 30 SCSI devices—such as very large arrays of high-performance hard disk drives, external sto

2Support for Older SCSI DevicesIf you have single-ended Ultra SCSI and earlier SCSI devices, Adaptec recommends that you connect them together on one

3After you turn off your computer and unplug the power cord, remove the cover from the computer.Locate an unused 64-bit PCI/PCI-X expansion slot and r

4Insert the Adaptec SCSI Card 39320 in the 64-bit (or 32-bit) PCI or PCI-X expansion slot; press down firmly until the card clicks into place, then re

5The Adaptec SCSI Card 39320 is preset to ID 7 for each channel and should not be changed. If you boot from a SCSI hard disk, make sure the hard disk

6The Adaptec SCSI Card 39320 has two separate Ultra320/160 SCSI channels, as shown in the figure on page 1. Both channels have an internal LVD/SE conn

7Plug the nonterminated end of the cable(s) to one of the internal LVD/SE connector.Plug the internal Ultra320/160 and Ultra2 SCSI devices to the othe

8Connecting External SCSI DevicesYou can connect external Ultra320/160 and Ultra2 SCSI devices to the 68-pin external LVD/SE SCSI connector. Each exte