Adaptec 2110S - SCSI RAID Controller Guia de Instalação descarregar pdf (Página 43)

3-8

Adaptec RAID Installation Guide

8 Select Other, then insert the driver disk you created in Step 3.

9 Select Adaptec I

O RAID Host Adapter Driver for NT 4.0.

10 Press Enter and continue with the installation as described in

the Windows NT documentation.

Installing the Driver in a New System with Other Hardware

In this scenario, you are installing an Adaptec RAID controller in a

new computer system with another controller from another

manufacturer or other hardware that requires the use of

Windows NT mass storage detection. To install the driver

1 Create a driver disk using the Adaptec RAID Installation CD. To

create a driver disk

a Insert the Adaptec RAID Installation CD in your drive.

b Start from the CD. The CD loads a Linux kernel that is used

to manage all of its functions.

c Follow instructions and respond to prompts as necessary to

get to the Adaptec splash screen.

d When you see the Adaptec splash screen, click Create

Driver Disk. Then, click the appropriate operating system.

e Insert a floppy disk and click OK. The system creates the

driver disk.

2 Shut down the system and remove the Adaptec RAID

Installation CD and the driver floppy disk.

3 Install and configure your Adaptec RAID controller and hard

drives according to the instructions in Chapter 2.

4 Start up the system. During startup, press Ctrl+A to start

SMOR. Use SMOR to create the RAID. For details, refer to

Using SMOR on page 2-11.

5 Insert the Windows NT CD in the drive and restart the system.

6 Press F6 when the “Inspecting your computer hardware”

screen appears.

COMBINED RAID IG.BOOK Page 8 Tuesday, September 25, 2001 5:46 PM

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 105 106

Sem comentários

Adaptec 2110S - SCSI RAID Controller Guia de Instalação Página 43