Adaptec 2110S - SCSI RAID Controller Guia de Instalação descarregar pdf (Página 44)

3-9

Installing the Driver

7 You are prompted to either press S to specify additional

controllers or press Enter to continue Windows NT installation

without specifying additional controllers.

Press S to Specify Additional Devices. Select Other, then insert

the driver disk you created in Step 1.

8 Select Adaptec I

O RAID Host Adapter Driver for NT 4.0.

9 Press Enter and continue with the installation according to the

instructions in the Windows NT documentation.

Upgrading the Controller in an Existing System

In this scenario, you are removing a controller from a working

Windows NT 4.0 system and substituting an Adaptec RAID

controller.

Note: If you have already installed an Adaptec RAID

controller in your system and want to change drivers, refer

to Changing the Driver in an Existing System on page 3-10

instead of this procedure.

To install the driver

Create a driver floppy disk using the

Adaptec RAID Installation CD

To create the disk

a Insert the Adaptec RAID Installation CD in your drive.

b Start from the CD. The CD loads a Linux kernel that is used

to manage all of its functions.

c Follow instructions and respond to prompts as necessary to

get to the Adaptec splash screen.

d When you see the Adaptec splash screen, click Create

Driver Disk. Then, click the appropriate operating system.

e Insert a floppy disk and click OK. The system creates the

driver disk.

2 Shut down the system and remove the Adaptec RAID

Installation CD and the driver floppy disk.

COMBINED RAID IG.BOOK Page 9 Tuesday, September 25, 2001 5:46 PM

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 105 106

Sem comentários

Adaptec 2110S - SCSI RAID Controller Guia de Instalação Página 44