Adaptec 1891300 - RAID Controller Guia do Utilizador Página 42
- Página / 137
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Chapter 5: Installing the Controller and Disk Drives ● 42
2 Install a terminator (or enable termination) on the disk drive at the end of each cable, or
the end of the cable itself.
Remove any terminators (or disable termination) on disk drives between the ends of each
cable.
Install your SCSI disk drives, following the instructions in your system’s documentation.
3 If space inside your computer cabinet is limited, connect your disk drives to the SCSI cable
before installing them. (For installation instructions, refer to your computer
documentation.)
Caution:
To avoid causing unstable operation, do not attach a cable to the controller
unless the other end of the cable is attached to a least one disk drive.
Alternatively, install your disk drives, then connect them to the controller.
4 When all internal disk drives have been installed and connected, close your computer
cabinet, reattach the power cord, then continue with the following section.
Connecting External Devices
Note: If you are not connecting any external devices, see the following section, Next Steps.
1
(SCSI controllers only) Ensure that SCSI IDs and termination are set before completing the
connections to external disk drives or devices. See page 41.
2 Use high-quality cables to connect your controller to your external device(s), such as disk
drives or disk drive enclosures.
Adaptec recommends using only Adaptec cables. For more information or to purchase
cables, visit the Adaptec Web site at www.adaptec.com.
Next Steps
If you are installing the controller driver and an operating system onto a bootable array,
continue with Creating a Bootable Array on page 43.
If you are completing a standard installation onto an existing operating system, continue with
Installing the Driver on an Existing Operating System on page 55.
Monitoring Disk Drives with Adaptec Storage Manager
Adaptec Storage Manager allows you to monitor the status of your SAS, SATA, or SCSI disk
drives. Within Adaptec Storage Manager, you can select a disk drive object and a command will
be sent to the backplane (for internal disk drives) or enclosure (for external disk drives). The
LED associated with that disk drive will flash. The following table describes the LED flash
states. For more information about backplanes, see Backplane Connections on page 72. For
more information about monitoring capabilities, refer to the Adaptec Storage Manager Help.
!
Controller Device State Slot State LED Flash State
Failed Device is faulty On
Rebuilding Device is rebuilding Slow flash
Blink Identify the device Fast flash
Other No error Off
- Installation and User’s Guide 1
- Copyright 2
- Trademarks 2
- Disclaimer 2
- Adaptec Customer Support 3
- Canadian Compliance Statement 5
- Contents 6
- Safety Information 10
- Technical Specifications 10
- About This Guide 11
- How to Find More Information 12
- Kit Contents and System 13
- Requirements 13
- Kit Contents 14
- About Your RAID Controller 15
- Array-level Features 16
- Adding Enhanced Features 17
- About the Adaptec 3085 18
- About the Adaptec 3405 19
- About the Adaptec 3805 20
- About the Adaptec 31205 21
- About the Adaptec 31605 22
- Mode 0 Flash connector 22
- About the Adaptec 4000 23
- About the Adaptec 4800SAS 24
- 256 MB also available 24
- About the Adaptec 4805SAS 25
- About the Adaptec 2420SA 26
- About the Adaptec 2820SA 27
- About the Adaptec 2130SLP 28
- About the Adaptec 2230SLP 29
- Getting Started 30
- Choosing a RAID Level 31
- Selecting Disk Drives 32
- Selecting Cables 33
- SATA Cables 34
- Installation Options 35
- Basic Installation Steps 35
- In this chapter 37
- Installing the Controller 38
- Connecting External Devices 42
- Creating a Bootable Array 43
- Setting the Boot Controller 44
- Creating an Array 44
- Making Your Array Bootable 47
- Installing the Driver and an 48
- Operating System 48
- Creating a Driver Disk 49
- Installing with Windows 50
- Installing with Red Hat Linux 50
- Installing with SUSE Linux 51
- Installing with NetWare 51
- Installing with OpenServer 52
- Installing with Solaris 52
- Installing with UnixWare 53
- Installing with VMware 53
- Installing with FreeBSD 54
- Installing on Windows 57
- Installing on NetWare 57
- Installing on OpenServer 58
- Installing on Solaris 58
- Installing on UnixWare 59
- Installing on VMware 59
- Installing on FreeBSD 60
- Managing Your Storage Space 61
- About Adaptec Storage Manager 62
- Which Utility Should I Use? 63
- Solving Problems 64
- Troubleshooting Checklist 65
- Silencing the Alarm 65
- Resetting the Controller 67
- ) Web site at www.scsita.org 68
- In this appendix 68
- What is SAS? 69
- What’s a Phy? 70
- What’s a SAS Port? 71
- What’s a SAS Address? 71
- What’s a SAS Connector? 71
- What do SAS Cables Look Like? 71
- Direct-attach Connections 72
- Backplane Connections 72
- SAS Expander Connections 73
- Understanding RAID 75
- Understanding Drive Segments 76
- Non-redundant Arrays (RAID 0) 76
- RAID 1 Arrays 77
- RAID 1 Enhanced Arrays 77
- RAID 10 Arrays 78
- RAID 5 Arrays 79
- RAID 5EE Arrays 80
- RAID 50 Arrays 81
- RAID 6 Arrays 82
- RAID 60 Arrays 82
- Selecting the Best RAID Level 83
- Using the Adaptec RAID 84
- Configuration Utility 84
- Running the ARC Utility 85
- Managing Existing Arrays 86
- Initializing Disk Drives 86
- Rescanning Disk Drives 86
- Secure Erasing Disk Drives 87
- Opening a -Select Utility 87
- Applying Changes and Exiting 87
- General Controller Settings 88
- Option Description 89
- Locating Disk Drives 91
- Identifying Disk Drives 91
- Viewing the Event Log 92
- Running the ACU Using Scripts 95
- About Record Mode 96
- Required 97
- ? Description 97
- HotspareDrives=0:0:0,0:1:0 98
- InitializeAll=Yes 98
- ACU exits with an error 99
- Keyword Description 100
- ACU Error Codes 101
- Sample Scripts 102
- System Requirements 105
- Before You Begin 105
- Running the Menu-based AFU 106
- Running the 107
- I2C Connector Reference 111
- Pin Number Signal Description 112
- 22-55-2161 114
- Pin Number 114
- SFF-8087 Connector J5: 125
- SFF-8087 Connector J18: 125
- SFF-8087 Connector J14: 125
- 22-552101 126
- SFF-8484 Connector J7: 128
- Electrostatic Discharge (ESD) 129
- Environmental Specifications 131
- DC Power Requirements 131
- Current Requirements 131
- Index ● 133 133
- Index ● 134 134
- Index ● 135 135
- Index ● 136 136
- Adaptec, Inc 137
- 691 South Milpitas Boulevard 137
- Milpitas, CA 95035 USA 137
Manuais e produtos relacionados com Controladores periféricos Adaptec 1891300 - RAID Controller
Samsung NV8 manuals
Owner’s manuals and user’s guides for DVD players Samsung NV8.
We providing pdf manuals Samsung NV8 for download free by document types:
More products and manuals for DVD players Samsung
| Models | Document Type |
|---|---|
| AH68-01959S |
User Manual
Samsung HT-TXQ120 User manual,
36 pages
|
| DVD-C631P |
User Manual
Samsung DVD-C631P User manual,
24 pages
|
| DVD-FP580 |
User Manual
Samsung DVD-FP580 User's Manual,
63 pages
|
| DVD-HD931 |
User Manual
Samsung DVD-HD931 User manual,
26 pages
|
| SP43T9 |
User Manual
Samsung SP-54T8HE User manual,
64 pages
|
| DVD-HD870 |
User Manual
Samsung DVD-HD870 User manual,
64 pages
|
| DVD-HD950 |
User Manual
Samsung DVD-HD950 User manual,
75 pages
|
| DVD-HR725 |
User Manual
Samsung DVD-HR725 User manual,
135 pages
|
| AK68-00102A |
User Manual
Samsung AK68-00102A User's Manual,
21 pages
|
| DVD-HD845 |
User Manual
Samsung DVD-HD845 User's Manual,
62 pages
|
| HT-TQ22 |
User Manual
Samsung HT-TQ22 User manual,
80 pages
|
| DVD-V6500 |
User Manual
Samsung DVD-V6500K User manual,
54 pages
|
| AH68-01008B |
User Manual
Samsung HT-DL200 User manual,
23 pages
|
| SN-324 |
User Manual
Samsung SN-324 User's Manual,
5 pages
|
| HT-TX75 |
User Manual
Samsung HT-TX75 User manual,
39 pages
|
| DVD-V8080 |
User Manual
Samsung DVD-V8080 User's Manual,
34 pages
|
| DVD-L300WDEU |
User Manual
Samsung DVD-L300WDEU User's Manual,
34 pages
|
| DVD-R160 |
User Manual
Samsung DVD-R160 User's Manual,
83 pages
|
| AH68-02293B |
User Manual
Samsung HT-C350 User manual,
39 pages
|
| DVD-R155 |
User Manual
Samsung DVD-R155 User's Manual,
75 pages
|
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.032 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais