Adaptec 2920C - AHA Guia de Instalação descarregar pdf (Página 5)

Step 6: Plug one end of the internal SCSI cable

into the host adapter’s internal SCSI connector.

■ If you purchased your host adapter in an Adaptec kit,

an internal SCSI cable that allows you to connect up

to two internal SCSI devices is included. If you are

connecting more than two internal SCSI devices, you

must obtain a 50-pin internal SCSI cable with enough

connectors to accommodate all of your devices.

■ Make sure the colored stripe on one side of the cable

is aligned with pin-1 of the host adapter’s connector.

Pin-1 of the connector is usually designated by a

small triangle (▲), or a “1” on the connector.

Step 7: Plug the other end of the cable into the last

internal device (this device must be terminated; see

Step 4).

Step 8: Plug the remaining connectors on the cable

into any remaining internal devices (these devices

must not be terminated; see Step 4).

Step 9: Connect an available DC power cable

(from your computer’s power supply) to the power

input connector on the SCSI device.

50-pin SCSI

Ribbon Cable

Pin 1

Internal SCSI

Connector

Colored

Stripe

Pin 1

Internal SCSI

Device

Colored Stripe

Pin 1

2nd Internal SCSI

Device

Colored Stripe

To 1st Internal

SCSI Device

To Host

Adapter

DC Power Cable

(from the Power Supply)

Power Input Connector on

the Back of the Drive

1 2 3 4 5 6 7 8 9 10 11

Comentários a estes Manuais

Sem comentários

Adaptec 2920C - AHA Guia de Instalação Página 5

Comentários a estes Manuais

Manuais e produtos relacionados com Conversores em série Adaptec 2920C - AHA