Adaptec 2200S - SCSI RAID Controller Guia de Instalação descarregar pdf (Página 25)

2-6

Adaptec SCSI RAID 2120S/2200S Installation Guide

The following figure shows various SCSI cabling examples, note

that all channels are shown as wide only.

Terminate your SCSI devices as shown in the examples, ensuring

that the cables are terminated, or the device at the end of a cable is

terminated, and the devices in the middle are not terminated. If

only one cable is attached, then one end is the controller, which

must have its termination set to auto.

Note:

Each channel being used on a multichannel RAID adapter

must be terminated properly for its configuration

T = Terminated

Internal

Wide SCSI

External

Wide SCSI

Internal

Wide SCSI

External

If using cables with attached mutimode terminators, as in the cable

supplied, configure controller termination to auto unless both

internal and external connectors are being used on that channel.

If narrow devices are being used, attach them using wide to narrow

adapters. If SE or other slower devices are being used, keep them

on the same channel, along with any narrow devices.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 66 67

Sem comentários

Adaptec 2200S - SCSI RAID Controller Guia de Instalação Página 25