Adaptec APA-1480 Manual do Utilizador Página 1

APA-1480 Enabler for DOS Copyright © APSoft, 2003

APSoft 4 Command Line Options. APA-1480 Enabler for DOS /ID Displays identified drive information. /BS Performs PCI bus scan and termination. Inform

APSoft APA-1480 Enabler for DOS Command Line Options. 5 /OZ:IL:<use> O2Micro PC Card adapter only: set/reset ISA Legacy bit /F=filename Specifi

3 C H A P T E R Initialization File The initialization file is a text file that contains special settings. These settings a

APSoft APA-1480 Enabler for DOS Initialization File 7 These parameters define the CardBus or PCI-to-PCI bridge memory filter base and limit (or size)

APSoft 8 Initialization File APA-1480 Enabler for DOS Control setting of VGA Enable bit in Bridge Control Register. Valid values are 0 and 1. Exampl

APSoft APA-1480 Enabler for DOS Initialization File 9 These options allow specifying values for card base address registers (BARs). Example: BAR0

A P P E N D I X Additional information How to get Technical Support for APA-1480 Enabler Please send an E-mail in Englis

APSoft APA-1480 Enabler for DOS Additional information 11 Example of INI file Following sample shows an example of UN1480 initialization file for the

APSoft 12 Additional information APA-1480 Enabler for DOS This page is intentionally blank.

CUSTOMER LICENSE AGREEMENT APSoft thanks you for selecting one of their products for your computer. This is the APSoft Customer License Agreement wh

APSoft ii APA-1480 Enabler for DOS Copyright Notice and Disclaimer Unless otherwise noted, this document and the information herein disclosed are pr

APSoft APA-1480 Enabler for DOS iii Table of Contents Introduction ...

APSoft iv APA-1480 Enabler for DOS This page is intentionally blank.

APSoft APA-1480 Enabler for DOS Introduction v Introduction This manual provides an overview of the Adaptec SlimSCSI 1480 CardBus Host Adapter (APA-1

APSoft vi Introduction APA-1480 Enabler for DOS APA-1480 Enabler may support simultaneously up to 16 SCSI Hard Disks per one Adaptec APA-1480 SlimSC

1 C H A P T E R Installation The APA-1480 Enabler may be installed either in CONFIG.SYS, AUTOEXEC.BAT or started from DOS c

APSoft 2 Installation APA-1480 Enabler for DOS … DEVICEHIGH=C:\ASPI8DOS.SYS /D … Fine-tuning If your BIOS configure CardBus Adapter properly, no com

2 C H A P T E R Command Line Options. Command line options can be specified in any order, either in upper case or in lower