Adaptec AVA-1505A Guia do Utilizador descarregar pdf (Página 12)

12 FAQ’s for Actel’s Antifuse FPGA Programming

3. From the File menu, select Properties > Shortcut.

4. Append devactivator2: <SCSI ID> to the command line, as shown below:

C:\actel\bin\apsw.exe devactivator2:4

19. How can I determine what IRQ and I/O addresses are used by the

installed add-in cards?

Ans. To determine the IRQ and I/O addresses being used by the installed add-in cards, follow the

instructions below:

1. Double-click the Computer icon. The Computer Properties window is displayed.

2. Click the Interrupt Request (IRQ) button to view the IRQ already in use.

3. Click the Input/output (I/O) button to view the I/O addresses already in use.

The default interrupt number is IRQ11, but can be set from IRQ9 to IRQ12. The default I/O address is

340h-35Fh, but can be set to 140h-15Fh. For information about changing the I/O address on the 1505A

card, refer to the Jumper Block Settings section in the Adaptec AVA-1505A AT-to-SCSI Host Adapter

Installation Guide.

If all the interrupts between IRQ9 and IRQ12 are being used, you must change the IRQ settings on

another card to free one of these interrupts for the 1505A card.

20. The green power light is blinking after I turn on the power in Activator.

What is the problem?

Ans. A self test has failed. Activator has been discontinued and Actel no longer supports failed units.

Refer to the Actel website for a list of supported programmers.

21. What does the error message “SCSI Controller not found” (PC only)

mean?

Ans. The SCSI controller board has not been installed in the PC or there is a SCSI I/O address conflict.

Also, verify that the device driver(s) were installed correctly. For more information, refer to

knowledgebase article 1184 (www.actel.com/kb/article.aspx?id=SL1184.)

22. What does the error message “Firmware load failed. WARNING: Could

Not Connect With Activator 2” mean?

Ans. This message is displayed by Actel's Windows Programming software when no contact with the

programmer can be found. If this occurs, check that you have turned on the Activator 2/2S programmer

and that the SCSI cable is correctly installed. Make sure that the SCSI cable connection is secure.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 32 33

Sem comentários

Adaptec AVA-1505A Guia do Utilizador Página 12