Adaptec AHA-3940W Guia de Instalação descarregar pdf (Página 10)

Document Title: AHA-3940/3940W Installation Guide

Part Number: 510595-00, Rev. A

Print Spec Number: 492699-00

Current Date: 8/25/94 ECN Date:08/30/94

Computer Will Not Boot from a SCSI Disk Drive

If both SCSI and non-SCSI disk drives are installed in

your computer, the non-SCSI drive is always the boot

device. If the computer has only SCSI disk drives,

check the following:

1 Make sure your computer’s CMOS

Setup

is set to

No Drives Installed, which is required for SCSI

host adapters.

2 Make sure the SCSI ID of the boot hard disk is 0

and that the boot partition is active. (The SCSI ID

is usually set with jumpers or switches on the

drive.)

3 If this does not solve the problem, back up all data

on the SCSI hard disk and perform a low-level

format with the SCSISelect Format Disk

option.

4 Partition the disk. See the MS-DOS User’s Guide

for instructions.

Adaptec Customer Support

■ For information on software upgrades, new releases, technical

advice, and other topics, call Adaptec’s Electronic Bulletin

Board Service (BBS) 24 hours a day at 408-945-7727; 1200, 2400,

9600, or 14400 baud, 8 data bits, 1 stop bit, no parity.

■ For the latest online information about Adaptec products and

services, call the Interactive FAX Service 23 hours a day at

408-957-7150.

■ For technical assistance, call Adaptec’s Technical Support Hot

Line at 800-959-SCSI (7274), or 408-945-2550.

M–F: 6:00 a.m.–5:00 p.m., Pacific Time.

■ To order Adaptec software, call 800-442-SCSI (7274) or

818-365-6264. M–F: 6:00 a.m.–5:00 p.m., Pacific Time. If you are

calling from outside the U.S. and Canada, the number is

408-957-SCSI (7274).

■ To request additional documentation for Adaptec products,

call 800-934-2766. M–F: 5:00 a.m.–6:00 p.m., Pacific Time.

1 2 ... 5 6 7 8 9 10 11 12

Sem comentários

Adaptec AHA-3940W Guia de Instalação Página 10