Adaptec AHA-3940W Guia de Instalação descarregar pdf (Página 3)

Document Title: AHA-3940/3940W Installation Guide

Part Number: 510595-00, Rev. A

Print Spec Number: 492699-00

Current Date: 8/25/94 ECN Date:08/30/94

Installing the Host Adapter

Inserting the Host Adapter in a PCI Slot

WARNING: Turn OFF and disconnect the

power to your computer and attached

devices before you remove the chassis cover.

1 Remove the cover from the computer case.

2 Locate an unused 5-volt PCI expansion slot that

supports bus mastering. Be sure that this slot is

not obstructed by other system hardware.

PCI bus slots are usually white or ivory and are

shorter than ISA or EISA slots. Usually there are

three PCI slots. One of these may be a shared slot.

That is, it may have an ISA or EISA connector and

a PCI connector, but only one kind of board can

be inserted in the slot at any one time.

3 Remove the corresponding expansion slot cover

from the computer chassis.

4 Position the host adapter directly over the bus

master PCI slot and insert the end of the board in

the card guide. Carefully press the bus connector

on the bottom of the host adapter down into the

slot.

5 Attach the host adapter bracket to the computer

chassis with the screw from the expansion slot

cover that you removed.

Note: Do not replace the chassis cover or

reconnect the power yet!

1 2 3 4 5 6 7 8 ... 11 12

Sem comentários

Adaptec AHA-3940W Guia de Instalação Página 3