
10
AMM-1525M/1510M/525M Installation Guide
Part Number: 510659-00, Rev. A
Print Spec Number: 492931-00
Current Date: 9/19/94 ECN Date: 9/27/94
Troubleshooting
If you are having problems with your adapter or
configuration, make sure the AMM-1525M/1510M/
525M is firmly seated and secured in the expansion
slot, then check the following:
Audio
■ To play audio CDs while in Windows, the [MCI]
CD Audio driver must be installed. Use the Driv-
ers option in Control Panel to install the driver.
SCSI (AMM-1525M/1510M only)
■ Are all SCSI devices powered with the SCSI bus
cables and power cables properly connected?
■ Since the AMM-1525M/1510M does not support
booting from a SCSI drive, is either a bootable
IDE drive installed in your computer or a boota-
ble SCSI subsystem present?
■ Does the host adapter and all devices on the SCSI
bus have unique SCSI IDs?
■ Is the SCSI bus properly terminated with only the
last SCSI device at the end of the bus terminated?
■ If your computer has multiple expansion boards
installed, did you assign each board a unique I/O
port address and IRQ channel?
IDE/ATAPI (AMM-1525M/525M only)
■ If you cannot access your IDE drives, try changing
the master IDE drive to the slave, and the slave
IDE drive to the master. Be sure to correctly con-
figure the drives in your computer’s CMOS setup.
■ If the previous step did not work, disconnect one
drive at a time from the IDE ribbon cable. When
either drive works correctly by itself, this proba-
bly indicates that the two drives are incompatible.
Adaptec Customer Support
■ For information on software upgrades, new releases, technical
advice, and other topics, call Adaptec’s Electronic Bulletin
Board Service (BBS) 23 hours a day at 408-945-7727; 1200/
2400/9600/14400 baud, 8 data bits, 1 stop bit, no parity. The
BBS is out of service 1 hour each day. If you cannot reach the
BBS, wait an hour and try again.
9
Comentários a estes Manuais