Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Guia de Instalação descarregar pdf (Página 112)

Defaults are shown in this typeface.

• IRQ Level: 2, 5,7,10

• I/O Address:

0x220, 0x240, 0x260, 0x280

• 8-bit DMA Channel: 0, 1,3

• 16-bit DMA Channel:

5,6,7

Known Problems and Limitations

The Sound Blaster card cannot share IRQ settings with any other card installed in

your system. The most common conﬂicts occur with the LPT1 parallel port or a

network card.

If your device is not a Plug and Play device and a hardware-jumpered IRQ

setting conﬂicts with another device, change the IRQ jumper setting on the

Sound Blaster card to one listed under “Supported Settings.”

Non-Plug and Play Sound Blaster 16, Sound Blaster Vibra 16, and Sound Blaster

AWE32 cards are all recognized as Sound Blaster 16 cards.

The ISA version IBM Token Ring and compatible adapters will not work in a

system that contains a Sound Blaster card that is conﬁgured at the default I/O

port address (0x220). If possible, move the Sound Blaster card to port address

0x240; otherwise, remove the Sound Blaster device from the system.

Conﬁguration Procedure

Hardware Conﬁguration

Note - Make sure you set the jumpers for the audio interface and not for the SCSI

interface, if your Sound Blaster 16 card has an on-board SCSI controller.

♦ If you have a Sound Blaster 16 card and you intend to use the SCSI interface,

you may have to set the jumpers that control the SCSI I/O address.

See the “Creative Labs Sound Blaster 16 SCSI-2 Interface” Device Reference Page

for information on setting the Sound Blaster 16 SCSI-2 jumpers, and make a note

of any changes.

100

Device Reference Manual for Solaris 2.6 (Intel Platform Edition) ♦ April 1998

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 126 127

Sem comentários

Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Guia de Instalação Página 112