Adaptec GDTSETUP Manual de Instalação Página 21

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 93
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 20
21
5HVXOW
HA Bus Target-ID LUN Device
00001
st
hard disk, Host Drive no. 0
(boot drive)
0020Streamer
0130CD-ROM
1000hard disk, Host Drive no. 0
1010hard disk, Host Drive no. 1
1020DAT
1030hard disk, Host Drive no.2
Important Note:
‘Not Direct Access Devices’ must not be connected to Bus 0, Target-ID 0,
LUN 0. This is reserved for the boot device under SCO Unix 3.2V5.0
,,)XUWKHU,QIRUPDWLRQ
From version 4.x of SCO UNIX V/386 3.2, a media change can be made with the UNIX
commands
MOUNT
and
UNMOUNT
. Please make sure that the removable hard disk
keeps its GDTSETUP drive number when changing the media, otherwise a separate
ID/LUN entry is necessary for each single media (since the drive number depends on
the media and not the device containing it).
SCO UNIX V/386 3.2v4.x and later versions support a maximum of 4 ICP Controllers in
one computer system.
The tool
GDTSYNC
in the directory '/etc' carries out a UNIX SYNC command (update
super block) and causes all buffers still present in GDT's cache to be written to the
Logical Drives. It is advisable to use this tool before shutting down the system.
When using Direct Access Devices with
exchangeable media
(e.g., removable hard disks),
a media has to be inserted when the system is booted, otherwise the device is not
available under UNIX.
"Not Direct Access Devices" (streamer, tapes, CD-ROMs, etc) can be switched on even
after system power up, they will still be recognised by
GDTSCAN
afterwards.
Vista de página 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 92 93

Comentários a estes Manuais

Sem comentários