Adaptec GDTSETUP Manual do Utilizador descarregar pdf (Página 72)

b.) Load GDTX000 automatically through the CONFIG.SYS file (DEVICE=GDTX000.EXE)

Note: GDTSETUP.EXE as well as GDTX000.EXE are on the System Disk - DOS.

If GDTSETUP was loaded this way, there is a "D" (Disk) behind the version number.

You may now ask what are the differences between the two GDTSETUP variants ?

They are small. The GDTSETUP variant loadable from disk under MS-DOS also additionally

allows the partitioning of Host Drives, which is not possible with GDTSETUP loaded from

the Flash-RAM. Loading GDTSETUP from the Flash-RAM is pretty easy, since there is

nothing more required to configure the disk arrays. User's, who have for instance, an NT

installation without a DOS partition, will highly appreciate this Flash-RAM-resident

GDTSETUP.

For our example, it is not relevant whether we load GDTSETUP from the Flash-RAM, or from

disk.

Now load GDTSETUP. The first menu asks you to select the desired ICP Controller. In our

example, there is only one ICP Controller installed in the system. Therefore, simply press

<ENTER> and then <F2> to select the Advanced Setup.

The main menu gives you the following options. As mentioned before, we have to go

through levels 1 to 4 to install the SCSI hard disk (with almost nothing to do on levels 3

and 4).

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 217 218

Sem comentários

Adaptec GDTSETUP Manual do Utilizador Página 72