Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Guia de Instalação descarregar pdf (Página 43)

Wall mounting the SIERRA™ plus film digitizer 41

VIDAR Film Digitizer Installation Guide

6. Connect the SCSI cable.

Note:

Before connecting the SCSI cable, be certain that the

SCSI cable isn’t connected to anything else and the digitizer

power supply is unplugged from the wall.

WARNING:

Inspect the pins! If the SCSI connector has bent

pins, it will damage the SCSI port in the digitizer. Do not

attempt to straighten bent pins. Discard any SCSI cable with

bent pins and replace it with a new cable.

a. Locate the SCSI cable.

b. Orient the SCSI connector as

shown here. 

c. Carefully attach the SCSI connector to the digitizer’s SCSI port

connector (located at the opposite end of the digitizer from the power

cable). Apply even pressure to avoid bending SCSI connector pins.

Do not force the connectors together.

SCSI cable

and connector

Bottom of digitizer

Toward rear of digitizer

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 85 86

Sem comentários

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Guia de Instalação Página 43