Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Guia de Instalação descarregar pdf (Página 58)

Installing SCSI software for the SIERRA™ plus film digitizer 56

VIDAR Film Digitizer Installation Guide

Computers with Windows NT 4.0

Note:

Windows NT Service Pack 6 is recommended.

1. Start Windows NT 4.0.

2. Click the Start button, click Settings, then click Control Panel.

3. In the Control Panel window, double-click SCSI Adapters.

4. In the SCSI Adapters window, click the Drivers tab.

5. In the Drivers tab, click Add.

6. In the Install Driver window, click Have Disk.

7. Insert the Adaptec Driver Installer diskette into the diskette drive.

8. In the Install from Disk window, type

a:\winnt

, then click OK.

9. Click Adaptec AIC-78xx PCI SCSI Controller Driver in the list.

Note:

If an Adaptec AIC-78xx driver is already installed, you’ll

be prompted for the current or new driver installation. Click

New

10. Go to “Using the SCSI Utility,” later in this chapter.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 85 86

Sem comentários

Adaptec 2930 - SCSI Card Ultra Storage Controller 20 MBps Guia de Instalação Página 58