Adaptec SCSI RAID 2120S Guia de Instalação descarregar pdf (Página 104)

3-73

container Commands

/extend_fs{=boolean}

Specifies whether to extend the file system so that it occupies

the entire reconfigured array. If you specify TRUE, the

command adds no new freespace and extends the file system

so that it occupies the entire reconfigured array. (The

command extends the file system after completing the

reconfigure operation.) If you specify FALSE, the command

adds freespace to the reconfigured array and does not extend

the file system to occupy the entire reconfigured array.

This switch defaults to FALSE.

This switch applies only to those multilevel volume sets on

which an NTFS file system resides. If you extend an NTFS file

system, you must reboot your system in order for the

extension to take effect.

If you do not specify this switch, you can later extend the file

system with the container extend file_system

command.

This switch is supported on Windows.

/mirror{=boolean}

Specifies whether to reconfigure the existing array into a

mirror set. If you specify TRUE, the command reconfigures

the existing array into a mirror set. If you specify FALSE, the

command does not reconfigure the existing array into a

mirror set.

This switch defaults to FALSE.

/partition_move{=boolean}

Specifies whether to move partitions instead of adding extra

space (using additional disks). If you specify TRUE, the

command moves partitions instead of adding extra space. If

you specify FALSE, the command does not move partitions.

This switch defaults to FALSE.

/partition_size{=integer}

Specifies the partition size. All partitions must be the same

size and you can specify only one partition per disk.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 277 278

Sem comentários

Adaptec SCSI RAID 2120S Guia de Instalação Página 104