Adaptec SCSI RAID 2120S Guia de Instalação descarregar pdf (Página 42)

3-11

container Commands

The following list describes the change to the display as the result

of creating a multilevel array of mirror sets with the container

create mmirror command:

■ The Dr column is blank to indicate that the newly created

mirror sets (63 and 62) do not have a drive letter assigned to

them.

■ The Type column displays Mirror for arrays 63 and 62 to

indicate that the underlying arrays are mirror sets.

■ The State column displays the state of the arrays, which in

this example are all in the Normal state.

Note that this column appears only if you specify the /full

switch with the container list command.

■ The Scsi C:ID:L column displays the SCSI device ID for the

disk(s) on which the underlying mirror set(s) reside. In the

example, mirror set 63 resides on disk 0:02:0 and 0:04:0.

Mirror set 62 resides on disk 0:03:0 and 0:05:0.

■ The Partition Offset:Size column displays the partition

offset(s) and size(s) for the underlying mirror set(s). In the

example mirror set 63 and 62 have partition offsets of 64.0 KB

and sizes of 15.0 MB.

If a partition is dead, the “:” (colon) in the Partition

Offset:Size column changes to a “!” (exclamation point). See

the disk remove dead_partitions (page 5-10)

command

for more information on dead partitions.

Related Commands

container commands:

■ container create mirror (page 3-5)

■ container list (page 3-50)

■ container promote (page 3-63)

disk commands:

■ disk remove dead_partitions (page 5-10)

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 277 278

Sem comentários

Adaptec SCSI RAID 2120S Guia de Instalação Página 42