Adaptec 2120S - SCSI RAID Controller Guia do Utilizador descarregar pdf (Página 229)

100

101

7-29

disk Commands

disk verify

To verify all blocks on a SCSI disk device and, optionally, repair any

bad blocks, use the disk verify command.

Syntax

disk verify [/repair{=boolean}] [/wait{=boolean}]

{scsi_device}

Parameters

{scsi_device}

Specifies the ID for the SCSI disk device that you want to

verify. A SCSI ID consists of a SCSI channel number (for

example, 0, 1, 2, 3, etc.), a SCSI device ID (0 through 15

inclusive), and a SCSI logical unit number (0 through 7

inclusive). See the scsi_device section on page 3-7 for more

information on how to specify the SCSI device.

Switches

/repair{=boolean}

Specifies whether to automatically repair bad blocks. If you set

this switch to TRUE, the command attempts to repair any bad

blocks. If you do not specify the switch, the command only

reports failures.

This switch defaults to FALSE.

/wait{=boolean}

Specifies whether to perform verification synchronously or

asynchronously. If you set this switch to TRUE, the command

performs the block verification synchronously and the

command prompt does not return until the block verification

operation completes.

The default is FALSE; that is, the command performs the

block verification asynchronously and the command prompt

returns immediately.

1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 353 354

Comentários a estes Manuais

Sem comentários

Adaptec 2120S - SCSI RAID Controller Guia do Utilizador Página 229

Comentários a estes Manuais

Manuais e produtos relacionados com Software Adaptec 2120S - SCSI RAID Controller