Adaptec 2120S - SCSI RAID Controller Guia do Utilizador descarregar pdf (Página 276)

11-12

Adaptec SCSI RAID Software Reference Guide

enclosure prepare slot

To indicate to the SAF-TE enclosure management device that it

should take the appropriate action to prepare the device in a specific

slot for removal or insertion, use the enclosure prepare slot

command.

This command may perform such operations as shutting off power

to the device slot. This allows users to safely remove a disk device

from or insert a disk device into the device slot.

Syntax

enclosure prepare slot {enclosure} {slot}

Parameters

{enclosure}

Specifies the ID associated with the enclosure management

device on which you want to prepare a slot. For this version,

the controller supports a maximum of eight enclosure

management devices on each bus.

{slot}

Specifies the unit number associated with the slot. This is the

slot that contains the device you want to prepare to make

available. This unit number can range from 0 to 15 inclusive.

Examples

Before preparing a device in the slot, you might want to use the

enclosure show slot command to determine the current

device slot status:

AAC0>enclosure show slot

Executing: enclosure show slot

Enclosure Slot scsiId Insert Status

--------- ---- ------ ------- ------------------------------------------

0 0 0:00:0 4 OK UNCONFIG ACTIVATE

0 1 0:01:0 0 OK UNCONFIG ACTIVATE

0 2 0:10:0 0 OK UNCONFIG ACTIVATE

0 3 0:03:0 0 OK UNCONFIG ACTIVATE

0 4 0:04:0 0 OK UNCONFIG ACTIVATE

1 0 1:00:0 0 OK CONFIG ACTIVATE

1 1 1:01:0 0 OK UNCONFIG ACTIVATE

1 2 1:10:0 0 OK UNCONFIG ACTIVATE

1 3 1:03:0 0 OK UNCONFIG ACTIVATE

1 4 1:04:0 0 OK UNCONFIG ACTIVATE

1 2 ... 271 272 273 274 275 276 277 278 279 280 281 ... 353 354

Sem comentários

Adaptec 2120S - SCSI RAID Controller Guia do Utilizador Página 276