Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Especificações descarregar pdf (Página 30)

Model PDP Series 200 maxDPU4E Hardware Guide

Flashing CP & IOM Firmware via Network Download

To perform a flash upgrade over the network, use the maxDPU4E flash

program at a maxSTATION. Should you experience continuous

problems with a network upgrade then, as a backup, you may perform

the upgrade using the 9-pin serial port located on the DPU chassis. This

chapter explains how to install firmware using either approach.

To download firmware over the maxNET network:

1. Plug DPU into chassis if this has not been done already.

2. Set Mode Switch to E and reset or power up the DPU. Wait until the

three top LEDs flash yellow. The DPU is now ready for flashing. If the

three top LEDs did not flash yellow, start over.

3. From the maxSTATION desktop, click the DPU4EFLASH icon to

access the Ethernet Flash DPU4E dialog box.

4. In the four fields labeled, Download DPU Image to IP, set the IP

Address to match the DPU4E’s IP Address Setting.

5. In the field labeled CP File to Download, use the default file

(c:\mcs\setup\nk.bin) to be flashed to the CP.

6. In the field labeled, IOM File to Download, use the default file

(c:\mcs\setup\iom4e.s3m) to be flashed to the IOM. Downloading the

IOM flash is the default setting and should be done when downloading

the CE image to make sure there is a consistent set of code in the DPU.

Metso Automation MAX Controls Inc. • 278590 •

5-2

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 57 58

Sem comentários

Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Especificações Página 30