Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Especificações descarregar pdf (Página 58)

Model PDP Series 200 maxDPU4E Hardware Guide

On the displayed menu screen cursor down to the selection: PM

Program Module <enter>.

The bottom of the display should show the program status:

Programming. Programmed.

On the displayed menu screen cursor down to the selection: VM

Verify Module. <enter>.

The bottom of the display should show the program status:

Verifying. Verified.

If an error in the programming or verification is reported, then

start over. You may need to use a shorter IOM cable from the

Parallel Port (<6 feet).

Remove DPU from the chassis and remove the IOM BDM cable.

Set the Mode Switches back to the ‘F’ Setting if you ready to

boot the DPU on line. If there is a new CP image to be flashed,

set the mode switch to the “E” position and proceed to the

section “CP Network Flash Programming Utility”.

Press the Reset button and observe the DPU starts up properly.

If other DPUs are to be flashed then go back to step 1. When

done, chose the menu option: QU Quit.

This will close the program.

This DPU does not have to be reloaded after this procedure has

been completed.

Metso Automation MAX Controls Inc. • 278590 •

A-12

1 2 ... 53 54 55 56 57 58

Sem comentários

Adaptec 1542B - AHA Storage Controller Fast SCSI 10 MBps Especificações Página 58