Adaptec AHA-1540CP Guia do Utilizador descarregar pdf (Página 107)

7-7

SCO UnixWare Installation

Rebuild the SCO UnixWare Kernel

To rebuild the UnixWare kernel with the new changes, follow these steps:

Type the following at the # prompt and press Enter after each line:

cd /etc/conf/bin

./idbuild -B

Status messages appear.

When the kernel has been built, type the following and press Enter

after each line (0 in -g0 is zero, not the letter O):

cd /etc/conf/cf.d

cp unix /stand/unix

cd /

shutdown -g0

Type y and press Enter when the computer asks if you really want to

shut down. System Is Down should appear on the screen.

The SCO UnixWare kernel is now ready for host adapter operation.

Boot the New Kernel

To reboot the computer with the new kernel, follow these steps:

Follow the onscreen instructions (usually by pressing Enter) to

reboot your computer.

Check the bootup messages to verify that all your installed SCSI

devices are listed.

If some or all of your installed SCSI devices do not appear at this

time, your SCSI cables may be loose, or the SCSI device setup may

not be complete. If so, go back and correct any problems before

proceeding.

Wait for SCO UnixWare to complete bootup with the new kernel.

Refer to Troubleshooting on page 7-11 if the computer crashes or if

panic (SCO UnixWare error) messages appear during bootup.

The updated driver for SCO UnixWare should now be ready to use.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 119 120

Sem comentários

Adaptec AHA-1540CP Guia do Utilizador Página 107