Adaptec SAS RAID Controllers Guia de Instalação descarregar pdf (Página 35)

Chapter 2 Hardware Installation and Removal 21

c. Power-on the disk drive enclosure, and verify that all available HDD status

indicators are normal for the storage enclosure(s) that they are in.

d. Power-on the computer system.

2. Enter the Open Boot Prompt (OBP) and use the show-disks command to list

the current devices.

In the following example, the HBA is the first device that is listed.

Note – Device paths might vary from this example, depending on which SPARC

system you are using and into which PCI-E slot the card is plugged.

3. Use the select command to select the device node for the HBA, and follow the

on-screen instructions by pressing Enter when prompted.

Note – When you run this command, omit /disk from the HBA device path, as

shown in the following example.

{0} ok show-disks

a) /pci@0/pci@0/pci@8/pci@0/pci@8/scsi@0/disk

b) /pci@0/pci@0/pci@2/scsi@0/disk

c) /pci@0/pci@0/pci@1/pci@0/pci@1/pci@0/usb@0,2/storage@2/disk

q) NO SELECTION

Enter Selection, q to quit: Chassis | critical: V_VCORE at /SYS/MB has

exceeded high warning threshold.

valid choice: a...c, q to quit q

{0} ok select /pci@0/pci@0/pci@8/pci@0/pci@8/scsi@0

Waiting for AAC Controller to start: . . . . . . . Started

Config Changes:

1 ->One or more device either moved or removed

or not responding or added

Press <ENTER> to accept current config changes - with in 30 seconds

(Default - Ignore changes and check the setup)

<ENTER> Pressed. Current Config is accepted

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 147 148

Sem comentários

Adaptec SAS RAID Controllers Guia de Instalação Página 35