Adaptec SAS RAID Controllers Guia de Instalação descarregar pdf (Página 81)

Appendix C Using the BIOS RAID Configuration Utility 67

■ The hard disk drive to be removed must not be a part of a logical device (its status

must be ‘available’).

■ After the hard disk drive is removed from the enclosure, you must perform a bus

scan by using the Rescan Drives option from the main menu of the Array

Configuration Utility (ACU).

■ You must confirm that the Disk Utility reports the correct configuration of the

attached target devices.

Hot-Plug Addition Conditions

Hot-plug, add, of HDDs is supported under the following conditions:

■ After the hard disk drive is added to the enclosure, you must perform a bus scan

by using the Rescan Drives option from the main menu of the ACU.

■ You must confirm that the Disk Utility reports the correct configuration of the

attached target devices.

Hot-Unplug and Plug Replacement/Reinsertion

Conditions

Hot unplug and plug, replace/reinsert, of HDDs is supported under the following

conditions:

■ The hard disk drive to be removed must not be a part of a logical device (its status

must be ‘available’).

■ If a hard disk drive is to be removed and replaced either into the same slot or a

different unused slot using the same disk drive or a new disk drive, you must

perform a bus scan between the removal and the replacement steps, as follows:

a. Remove the selected hard disk drive.

b. Complete a bus scan by using the Rescan Drives option in the ACU.

c. Confirm that the Disk Utility reports the correct configuration of attached

target devices

d. Replace/reinsert the hard disk (new or same) into the enclosure slot (same or

another unused slot).

e. Complete a bus scan by using the Rescan Drives option in the ACU.

f. Confirm that Disk Utility reports the correct configuration of attached target

devices.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 147 148

Sem comentários

Adaptec SAS RAID Controllers Guia de Instalação Página 81