Adaptec SAS RAID Controllers Guia de Instalação descarregar pdf (Página 87)

Appendix C Using the BIOS RAID Configuration Utility 73

2. Select the disk drive being secure erased, then press Ctrl+Q.

The secure erase stops and the ACU returns to its main window.

Using the -Select Utility to Modify HBA

Settings

Included in the BIOS RAID Configuration utility is a tool for modifying the settings

of the HBA and the disk drives connected to it. This utility is called SerialSelect or

SATASelect. This section contains the following subsections:

■ “To Start Using a -Select Utility” on page 73

■ “To Apply Changes and Exit a -Select Utility” on page 73

■ “To Modify General HBA Settings With a -Select Utility” on page 74

■ “To Modify SAS-Specific HBA Settings With a -Select Utility” on page 75

▼ To Start Using a -Select Utility

1. Start the BIOS RAID Configuration utility (see “To Start the BIOS RAID

Configuration Utility” on page 68), select the -Select utility, and press Enter.

2. Follow the on-screen instructions to modify the settings of the HBA and

connected disk drives, as required.

▼ To Apply Changes and Exit a -Select Utility

1. Press Esc until you are prompted to exit.

If you modified any settings, you are prompted to save the changes before you

exit.

2. Select Yes to exit, then press any key to restart your computer.

Any changes you made take effect after the computer restarts.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 147 148

Sem comentários

Adaptec SAS RAID Controllers Guia de Instalação Página 87