Adaptec SAS RAID Controllers Guia de Instalação descarregar pdf (Página 45)

Chapter 3 Creating a Bootable Array on an x64 System 31

Making the Array Bootable

Note – You may need to change the system BIOS to modify the boot order. For more

information, refer to your computer documentation or see “Best Practices For

Controlling the Boot Order of Logical Drives” on page 87.

The Sun StorageTek SAS RAID Internal HBA always uses the lowest numbered

array as its bootable array.

▼ To Make the Array Bootable

1. Select Manage Arrays from the main ACU menu.

2. Select the array that you want to make bootable, then press Ctrl+B.

Note – You cannot make an array bootable while it is building, verifying, or

rebuilding.

The number of the array changes to Array 00, which makes this array the boot

array for the Sun StorageTek SAS RAID Internal HBA.

3. Restart the computer.

Setting the Boot HBA

The Sun StorageTek SAS RAID Internal HBA supports bootable disk drives and

bootable arrays. You can configure the computer system to boot from either a disk

drive or an array connected to the HBA.

▼ To Set the Boot HBA

Note – For more information about completing these steps, refer to your computer

documentation.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 147 148

Sem comentários

Adaptec SAS RAID Controllers Guia de Instalação Página 45