Adaptec SAS RAID Controllers Guia de Instalação descarregar pdf (Página 39)

Chapter 2 Hardware Installation and Removal 25

e. Highlight Test and press Enter. Verify a 3-second audible alarm.

9. Verify that all target devices are present:

a. Press Esc until you reach the controller Options menu.

b. Highlight Disk Utilities and press Enter.

You will see an indication that the HBA is scanning SAS devices.

c. After the scanning completes, verify that all attached target devices are

displayed.

d. Press Esc to exit.

If no errors or issues are discovered, continue to the next section to complete the

installation process. If any issues are discovered, correct them and retest the HBA

before continuing.

Next Steps

If you are installing an operating system onto a bootable array, continue with one of

these sections, depending on whether you use an x64 or SPARC system:

■ “Creating a Bootable Array on an x64 System” on page 27

■ “Creating a Bootable Array on a SPARC System” on page 33.

If you are completing a standard installation onto an existing operating system,

continue with “Installing the Driver on an Existing Operating System” on page 49.

Removing the Hardware

The following instructions describe the tasks required to remove the HBA. If you

need to replace a failed HBA, remove the hardware, as described in this section, and

see “Best Practices For Replacing an HBA” on page 88.

Caution – Never remove the HBA when an attached array is in the process of

rebuilding a logical drive from a “Degraded” state.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 147 148

Sem comentários

Adaptec SAS RAID Controllers Guia de Instalação Página 39